They are used in place of the pen bushings for applying the finish to your pens. When ready to CA Wood Finish, remove metal bushings and replace with these bushings that are specially designed to resist CA glue. Makes your finishing process not only cleaner, but much easier! Fits on 7mm...
12 Cavity silicone mould for pen blank. Each cavity size: 2.5*7.5cm. Total size: 29.5*17cm. Perfect for that just right size pen blanks. Save your resin with this handy tool. With ”Tube-in" casting, you can attach small objects or designs of your choice to the brass tube before casting.
INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints...
INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead...
INSTA-SET is a catalyst which acts as an accelerator that allows CAs to quickly cure in thick layers by enhancing the alkaline conditions during polymerization. INSTA-SET in a spray bottle is normally used to cure the CA that flows from joints when parts are pressed together. Applying an additional bead...
INSTA-CURE has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs...
2#. The mandrel easily adapts to different length projects. They include 5 slimline bushings & a case for safe keeping.
Always check you user manual to make sure you get the correct mandrel size.
INSTA-CURE+ is a higher viscosity CA for loose fitting joints in which the adhesive must bridge gaps. Normally, the thicker CA is applied to one surface and then the parts are held tightly together for about 5 to 15 seconds. For large surface areas, including those with close fitting joints...
Materials: Carbon steel. You can use tube chamfering tool after each squaring of the blank. It will aide in preventing the ends of your pen blanks cracking during assembly.
MAXI-CURE extra thick CA is the best CA for most plastics, including GE?s Lexan MAXI-CURE is the best choice for plastic model assembly. When used with INSTA-SET, it works better than any putty for modifying or filling voids. It can be carved with a knife or razor blade and sanded...
INSTA-CURE has a water-thin viscosity that wicks deep into joints by capillary action and cures in a matter of a few seconds. Surfaces to be bonded must be tight fitting and should be held together while you apply the CA around the edges of the seam. At the moment CAs...